4 residual hazards, Residual hazards, Safety instructions – Lenze SDSGS User Manual
Page 11
Safety instructions
Residual hazards
l
11
BA 13.0011−EN 1.0
2.4
Residual hazards
Protection of persons
ƒ
Do not use the integrated brakes as fail−safe brakes. It cannot be ruled out that
certain disruptive factors that cannot be influenced such as oil ingress due to a
defective shaft sealing ring at the drive end may reduce the braking torque.
Motor protection
ƒ
Integrated temperature sensors do not provide full protection for the machine. If
necessary, limit the maximum current. Parameterise the controller so that the
motor will be switched off with I > I
r
after a few seconds of operation, especially if
there is a risk of blocking.
ƒ
If deviations from normal operation occur, e.g. increased temperature, noise,
vibration, determine the cause and, if necessary, contact the manufacturer. If in
doubt, switch off the low−voltage machine.
ƒ
Overload protection does not protect against overloading under all conditions.