3 condensation drain hole of the motor, 4 mounting, 1 mounting gearboxes with solid shafts – Lenze g500 User Manual
Page 14: Condensation drain hole of the motor, Mounting, Mounting gearboxes with solid shafts, Mechanical installation
Mechanical installation
Mounting
Condensation drain hole of the motor
EN
14
Lenze ¯ MA 12.0014 ¯ 1.0
4.3.3
Condensation drain hole of the motor
)
Note!
Lenze delivers motors with condensation drain holes with sealed
condensation drain holes. The holes are sealed with a plastic plug or a
locking screw. This does not affect the type of protection and the motor is
protected against the ingress of foreign substances during transport and
operation. Further information, (
¶ 34).
4.4
Mounting
4.4.1
Mounting gearboxes with solid shafts
¯
Draw the transmission elements onto the output shaft only by using the
centering thread.
(
Stop!
Shocks and blows to the shafts damage the roller bearings.
4.4.2
Attachment of motors to gearboxes with bearing housing (input design N)
g500−H_000.iso
Fig. 2
Input side design N
0
Spider / gear rim
1
Locking screw
1
Coupling hub
2
Keyway