Lenze g500 - Manual (Page 23)

Mechanical installation
Mounting
Mounting the fixed cover
4
EN
23 Lenze ¯ MA 12.0014 ¯ 1.0
4.4.6 Mounting the fixed cover
)
Note!
This cover is supplied loose on delivery!
X
X
Clip the protection cover on the bore holes.
4.4.7 Mounting the hoseproof hollow shaft cover
1
3
2
4
3x120°
Fig. 9
1 Protection cover
2 Cheese head screw
3 Thread reducing sleeve
4 Seal
1. Screw the three reducing bushes (3) into the flange with a screwdriver so they are
flush and staggered by 120°.
2. Fit seal (4) between flange and protective cap (1).
3. Fasten the protective cap (1) over the reducing bushes (3) on the flange using
three cheese head screws (2).