Lenze E82ZBL-C - Manual (Page 61)

Electrical installation
Wiring according to EMC
6
EDKMF2102 DE/EN/FR 7.1
61
l
H2_EMV_Verdraht−EMV
Wiring according to EMC
For wiring according to EMC requirements observe the following points:
)
Note!
ƒ Separate control/data cables from motor cables.
ƒ In case of digital signals, connect the shields of control/data cables on both
sides.
ƒ Use an equalizing conductor with a cross−section of at least 16 mm 2 to
avoid potential differences between the bus nodes (reference: PE).
ƒ Observe the other notes concerning EMC−compliant wiring given in the
documentation for the standard device.