Lenze E82ZAFCC200 - Manual (Page 56)

7 Commissioning
Possible settings via DIP switch
EDK82ZAFCC-200 DE/EN/FR 4.0
56

H1inbet-Baudrate
7 Commissioning Possible settings via DIP switch
ON
OFF
1 6
ON
2 7 3 8 4 9 5 10
The DIP switches on the front serve to set the
ƒ node address (switches 1 ... 6)
ƒ baud rate (switches 7 ... 9)
Switch 10 does not have any function.
The Lenze setting of all DIP switches is OFF.

Note!
Settings via codes
ƒ In the Lenze setting (all switches OFF), all values from codes C0350 (node
address) and C0351 (baud rate) are accepted.
ƒ Changes to codes are accepted by:
– A voltage supply switch-off and switch-on or
– A ”Reset node” with C0358 = 1
ƒ C0350 is inactive if at least one of the switches 1 ... 6 has been set to the
ON position before the mains is reconnected.
ƒ C0351 is inactive if at least one of the switches 7 ... 9 has been set to the
ON position before the mains is reconnected.
ƒ Detailed information on the codes is provided in the CAN communication
manual and the documentation of the standard device.