Lenze E82ZAFBC201 - Manual (Page 36)

5 Electrical installation
Wiring
EDK82ZAFBC−201 DE/EN/FR 5.0
36
l
H1_E_INST−INS_Klemmenbeleg
Wiring
0
1
E82ZAFB211
1. Wire the fieldbus function module 0.
– Remove approx. 10 cm of the cable sheath.
– Connect the shield to the shield sheet using the cable tie.
– Wire the fieldbus function module (see corresponding Mounting Instructions).
Terminal 28 (controller inhibit) of the bus function module
0 is inactive. Controller is
inhibited via terminal 28 of the bus−I/O function module.
2. Wire the bus−I/O function module 1 (terminal assignment ^ 39 ).
3. Connect mains and motor (see Mounting Instructions for the 8200 motec).