Lenze MCH Series Drives - Manual (Page 11)

RG-MHBAC 8
BACnet Objects
4 MCH BACnet® Objects
The MCH BACnet® Objects are divided into seven types: analog input, analog value, binary input, binary
output, binary value, multi-state input and multi-state value. Sections 4.2 through 4.8 describe each of
these object types and the individual object instances within each.
4.1 BACnet® Object Map
Table 2: BACnet® Object Map for MCH Series Drives
Object
Type 1
Object
Instance
Description (Object Name) Point
Units Resolution Texts Number
of States
Default
Value
Inactive Active
AI 1 Actual Frequency (OUTPUT FREQ) Hz 0.01 -- -- -- 0
AI 2 Command Frequency (COMMAND FREQ) Hz 0.01 -- -- -- 20.00
AI 3 Load Percent (LOAD PERCENT) % 1.00 -- -- -- 0
AI 4 Total Runtime (RUNTIME HRS) Hr 1.00 -- -- -- 0
AI 5 DC Bus Voltage (DC BUS VOLTS) % 1.00 -- -- -- 0
AI 6 PID Setpoint Command (PID SETPOINT) % 1.00 -- -- -- 50
AI 7 PID Feedback (PID FEEDBACK) % 1.00 -- -- -- 0
AV 1 Keypad Speed Command (KEY SPD CMD) Hz 0.01 -- -- -- 20.00
AV 2 Keypad Setpoint Command (KEY STPT CMD) % 1.00 -- -- -- 50
BI 1 Run/Stop Status (RUN_STOP) -- 1.00 STP RUN -- STP
BI 2 Current Direction (DIRECTION) -- 1.00 FWD REV -- FWD
BI 3 Fault Condition (OK_FAULT) -- 1.00 OK FLT -- OK
BI 4 TB-14 / Relay #2 (TB14_RELAY2) -- 1.00 OFF ON -- OFF
BI 5 TB-15 / Relay #3 (TB15_RELAY3) -- 1.00 OFF ON -- OFF
BI 6 Relay #1 (RELAY1) -- 1.00 OFF ON -- OFF
BO 1 Start/Stop Drive (CMD RUN_STOP) -- 1.00 STP RUN -- STP
BV 1 Clear Present Fault (CLEAR FAULT) -- 1.00 NRM CLR -- NRM
MSI 1 Operational Status (RUN STATUS) -- 1.00 -- -- 16 12
MSI 2 Present Fault (FAULT) -- 1.00 -- -- 25 0
MSI 3 PID Mode (PID MODE) -- 1.00 -- -- 3 0
MSI 4 H/O/A Mode (HOA MODE) -- 1.00 -- -- 3 0
MSI 5 Speed/Setpoint Reference (SPD_STPT REF) -- 1.00 -- -- 19 0
MSV 1 Speed Source Selection (SOURCE SEL) -- 1.00 -- -- 3 0
NOTES:
1. Object Types:
AI = Analog Input; AV = Analog Value;
BI = Binary Input; BO = Binary Output; BV = Binary Value;
MSI = Multi-State Input; MSV = Multi-State Value