Lenze MCH Series Drives - Manual (Page 16)

13 RG-MHBAC
BACnet Objects
State Name Description Reference
12 -VDC 0-10 VDC on TB-5A (Closed loop setpoint control - PID Enabled)
13 -IDC 4-20 mA on TB-5B (Closed loop setpoint control - PID Enabled)
14 SP#1 Preset Setpoint #1 (Closed loop setpoint control - PID Enabled)
15 SP#2 Preset Setpoint #2 (Closed loop setpoint control - PID Enabled)
16 SP#3 Preset Speed #3 (Open loop speed control - PID Enabled)
17 SP#4 Preset Setpoint #4 (Closed loop setpoint control - PID Enabled)
18 -MOP Motor Operated Pot (Closed loop setpoint control - PID Enabled)
19 -SER Serial Setpoint Command (Closed loop setpoint control - PID Enabled)
4.8 Multi-State Value (MSV) Object Descriptions
Object MSV-1: Speed Source Selection
This object mimics the functionality of the SPEED SOURCE key on the drive keypad. It
is used to determine whether the drive will get its speed/setpoint reference from Drive
Parameter #24 (Auto Source) or Drive Parameter #29 (Hand Source).
State Name Reference Source
1 NORMAL Normal Source
2 HAND Hand Source Only
3 AUTO Auto Source Only
This object allows the user to toggle between OPEN loop speed control and CLOSED loop
PID control when PID mode is ENABLED (refer to MSI-3). The ability to command this
object through the LAN is dictated by Drive Parameter #30 (Control) and the drive HOA
(refer to MSI-4)
For more information on SPEED SOURCE, refer to the MCH Installation and Operation Manual (MH01).
4.9 Reference and Links
MCH Series Variable Frequency Drives visit:
http://www.lenze-actech.com
BACnet and ASHRAE, Inc. visit:
http://www.bacnet.org