Lenze EPM−H507 - Manual (Page 53)

Preface and general information
About these Operating Instructions
1
l
53 EDBPM−H505 DE/EN/FR 6.1
1 Preface and general information
Use the EPM−H505 and EPM−H507 operating units to access codes of Lenze
controllers and control them in a comfortable way. Communication takes place
via system bus (CAN).
The Lenze software »HMI Designer« is a powerful development tool for creating
projects containing the configuration of the operating unit.
1.1 About these Operating Instructions
ƒ These Operating Instructions are designed to ensure safe and trouble−free
working on and with the EPM−H505 and EPM−H507 operating units.
ƒ All persons working on and with the EPM−H505 and EPM−H507 operating
units must keep these Operating Instructions at hand and observe all
relevant information and notes.
ƒ These Operating Instructions must always be kept as a complete
document and in a readable state.
1.2 Terminology used
Term Used in this text for
Controller Lenze 8200 vector and 9300 vector frequency inverter, Lenze 9300
and 9400 servo inverter
HMI Human Machine Interface
1.3 Scope of supply
Quantity Important
1 operating unit, EPM−H505 or EPM−H507
1 Operating Instructions
4 mounting clamps
4 screws M4 × 35 mm
1 seal
1 4−pole terminal strip for connection of
DC voltage supply
1 5−pole terminal strip for system bus
(CAN) connection After receipt of the delivery, immediately check
whether the items delivered match the
accompanying papers. Lenze does not accept any
liability for deficiencies claimed subsequently.
Claim
l visible transport damage immediately to the
forwarder.
l visible deficiencies/incompleteness immediately
to your Lenze representative.