Lenze Engineer v2.21 - Manual (Page 282)

Appendix
Creating cam data with the »Cam Editor«
282
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
ViewInterpolation mode Change to the interpolation mode.
• Starting from an ideal, complete cam that was calculated
in connection mode, table interpolation is carried out. The
table contains the interpolation points of a linear
interpolation.
• Note: The button is only active in the Expert mode of the
»Cam Editor«!
• If the Expert mode has been deactivated, all the
necessary steps automatically take place when the
buttons Curve mode and/or Interpolation mode are
clicked.
EditStart calculation... Calculate cam in the connection or interpolation mode and
arrange interpolation points optimally.
• Note: The button is only active in the Expert mode of the
»Cam Editor«!
• If the Expert mode has been deactivated, all the
necessary steps automatically take place when the
buttons Curve mode and/or Interpolation mode are
clicked.
Icon Menu command Function