Marshalltown SP684 SURFACE SHARK Surface Planer - Manual (Page 20)

PAGE 20 SP684 SuRFACE ShARK SuRFACE PLANER
FIGuRE 14
2) Install a spacer washer next to the outside side plate
of the wide section. Next, install a flail. Follow with a
spacer washer and continue the sequence until the
section is full. FIGuRE 15.
FIGuRE 15
Normal Installation Procedure (fine finish) for
Pentagonal Flails:
1) Install a spacer washer next to the outside side plate
of the narrow section. Next, install a flail. Follow with
a spacer washer and continue the sequence until the
section is full. FIGuRE 16.
FIGuRE 16
2) Install a flail next to the outside side plate of the wide
section. Next, install a spacer washer. Follow with a
flail and continue the sequence until the section is full.
FIGuRE 17.
FIGuRE 17
Normal Installation Procedure for Milling Flails:
1) Install three spacer washers next to the outside side
plate of the narrow section. Next, install a flail. Follow
with two spacer washers and continue the sequence
until the section is full. The tungsten carbide inserts
must be installed to form a continuous planing surface.
FIGuRE 18.