Marshalltown SP684 SURFACE SHARK Surface Planer - Manual (Page 34)

PAGE 34 SP684 SuRFACE ShARK SuRFACE PLANER
adhesive/sealant to the outside diameter of the
bearing. using the same support blocking, press the
replacement bearing into the bearing housing until it
seats itself against the flange. FIGuRE 38.
FIGuRE 36
FIGuRE 37
10) Position the bearing block on the arbor press with
the exposed side of the bearing facing up. Support the
inner race of the bearing by centering the 2-1/16 inch
outside diameter sleeve. This will properly absorb the
thrust against the inner race created by pressing the
driveshaft into the bearing. FIGuRE 39.
11) Clean the bearing journal area of the driveshaft
with a suitable solvent. Apply a suitable amount of
anaerobic adhesive/sealant to the bearing journal area
of the driveshaft. Press the driveshaft into the bearing
housing until it seats against the bearing. FIGuRE 40.
12) Reinstall the snap ring on the driveshaft.
Wear safety glasses and other appropriate safety
apparel when removing the snap ring or performing
any work with an arbor press. Caution all onlookers
about the possibility of flying debris and personal
injury.
FIGuRE 38
FIGuRE 39