MK Diamond MK-101 Lowes - Manual (Page 19)

19
MK-101 aSSeMBlY
The Adjustable Cutting Guide can be used on either side of the Diamond Blade.
aDJUSTaBle CUTTiNG GUiDe iNSTallaTiON
(A)
Loosen Adjustable Cutting
Guide retaining thumbscrew
and place it over the Movable
Cutting Table Ruler/Stop
(B)
Place the Adjustable Cutting
Guide onto the Movable Cutting
Table Ruler/Stop and tighten the
retaining thumbscrew
SPlaSH GUaRD iNSTallaTiON
(A)
Install the retaining thumbscrew
through the washer and Splash Guard
then align to the hole found on back
of the Blade Guard and tighten
waTeR PUMP PRePaRaTiON
(A)
Press one end of the Cooling
Transfer Tube into the Water
Pump Discharge Fitting
(B)
Slide Cooling Flow Adjust-
ing clamp on to the Cooling
Transfer Tube
NOTe: