MK Diamond Higgins Jig - Manual

1315 Storm Parkway, Torrance, CA 90501 | P 800.421.5830 | www.mkdiamond.com | F 310.539.5158
The Higgins Jig is an exceptionally fast and safe tool for producing 2 x 8 right angle corners, paver corners, and lintel
corners. Setup for cutting is a simple two step process that involves no tools of any kind. First, the cutting depth is set by
adjusting the cutting head height to the thickness of the specified veneer. Second, the distance between the left side of
the jig is adjusted to the desired veneer thickness and then locked into place with the quick lever adjustment.
Once the jig is adjusted and the cutting head height locked in, the operator can switch between all three types of cuts
without any change to the cutting setup. The reliable accuracy of the Higgins Jig provides a consistent axis point on both
cuts and eliminates the need to clean out any residual material inside the corner veneer.
The Higgins Jig can also be used to cut veneer corners in river rock and other irregularly shaped materials.
Higgins Jig Instructional Sheet
Place Higgins jig on saw.
Place brick on table and turn
on saw.
Pull table back through brick
and flip brick vertically.
Adjust the height of the cutting head to
the desired depth and lock down.
Adjust jig to desired width.
Place left-hand on jig.
Make vertical cut.
Lock jig in place with orange lever.
Place right-hand on jig. Start cutting.
Corner Cutting Set-up (Jig Part# 169548)