MTS DCPD Measurement System - Manual (Page 19)

Description Label Item
Cable connector to controller DIO. Control 7
Power switch: I = on, O = off. I/O 8
Chassis and earth ground connections. Grounds 9
Standard AC power plug. Input Power 10
Connector pairs: orange are analog outputs to the
controller; green and yellow and connections to the Channel n 11
preamp. A typical DCPD system supports a single
reference specimen and a single active specimen.
Connects between the DCPD box and the reference
specimen and active specimen(s). One preamp is
required for every two specimens Preamp 12
.
Status Lights (Front View)
Description Light
When lit, indicates that mains power is switched on, but specimen current is
either switched off or is at a setting below that for normal testing, or the
specimen is not connected. Red
Indicates that specimen current is being provided to the specimen, but not at
a low current setting. Green
For more information on the status lights, see the Troubleshooting chapter.
DCPD Measurement System | 19
Introduction