MTS Model 680-01 High-Temperature Grips - Manual (Page 22)

Model 680.01 High-Temperature Grips 22
Install the Grips
An attachment kit is required for attaching each grip to the load unit. Kit
selection should be based on the mounting threads provided on the grips, which
must match corresponding threads on the device (force transducer or actuator
rod), to which the grip is to be attached. Refer to the information about the
attachment kits.
Grip Installation Components
Required equipment
• An attachment kit for the actuator
• An attachment kit for the force transducer
• Molykote G•N paste lubricant (MTS part number 011-010-217 is a 2.8 oz.
tube; other sizes are available)
Crosshead or
Force Transducer
Spiral
Washer
Set
Stud
Upper Grip
Lower Grip
Spiral
Washer
Set
Stud
Actuator Rod
Load Unit
Base Plate