MTS Insight Material Testing Systems - Manual (Page 17)

Specifications
MTS Insight™ Material Testing System Introduction 17
Specifications
This section provides general specifications for the MTS Insight Material Testing
System frames and illustrations of the crosshead and baseplate threaded hole
patterns for mounting fixtures.
Note At the time of this printing, some specifications have not been tested and
calculated specifications are provided in the following tables.
Consequently, specifications are subject to change without notice.
Contact MTS for verification if critical specifications.
General Specifications
The following specifications are for all MTS Insight frames. Specifications for
the specific models and in the following tables.
Parameter Specification
Environmental
Temperature
Relative humidity
Altitude
For indoor use only
5 to 40 °C
10 to 85%, noncondensing
For use at altitudes up to 2000 m
(6500 ft)
Power
Insulation over voltage
Pollution degree
Category II
2