MTS Insight - 1kN to 300kN - Manual (Page 57)

Insight Material Testing System Operation 57
Operation
This section describes the actions performed during normal, day-to-
day operation of the MTS Insight frame. For information on using the
MTS Insight frame in actual testing, refer to the TestWorks software
manual.
Contents
Hazard Icons 58
Main Power Switch (I/O) and E-Stop 59
Travel Limit Switches (Physical Limits) 60
Crush Zone Hazards 62
Fixture Mounting 63
Load Cell Mounting 64
Handset Control 68
Do not operate the MTS Insight test frame without the side covers and
bellows in place.
Operating the machine without side covers or bellows in place can expose
the operator to moving parts that could cause injury if contact is made.
Keep the area clean.
Sample debris can enter the side covers and puncture bellows causing erratic
machine operation.
Damaged bellows should be replaced before operating the MTS Insight Test
Frame.
Users should be aware of the potential of material fragments puncturing the
bellows and damaging the ball screw; user needs to be aware of the material
properties and the hazards generated by the materials during testing. Refer to
“General cleaning” on page 71.
Keep the testing area secure.
Only qualified, trained personnel should be allowed to operate the machine.
Keep bystanders away during machine operation.
CAUTION
CAUTION
CAUTION