MTS Landmark TWX - Manual (Page 67)

Note: This window may not appear in all cases.
5. Select a configuration and parameter set.
Under normal circumstances, you would select a configuration file and parameter set recommended
by the experts in your lab. However, for this example test, select the Training config.cfg configuration
but do not click OK yet.
Parameter sets are found in the lower left corner of the Open Station window. For this example test,
select the hard specimen tuning parameter set and click Open. A set of windows may open based
on the last user’s window setup. Minimize any windows that appear as you will be maximizing them as
appropriate.
6. Ensure that the HSM (hydraulic service manifold) is off.
MTS Landmark Test System Operation | 67
Running the Example Tension Test