Iv.b. attaching the adapters to the housing – Purenex Multipure Aquaversa for model MP750SB User Manual
Page 12
Multi-Pure's below sink Models are designed for use under your sink. Your Below Sink Unit is shipped with the adapta
valve installation kit. If you determine that you need fixtures different from those included with your shipment,
please contact Multi-Pure's Customer Relations office at 800-622-9206, extension 175.
Now that you have completed the faucet installation and connected to the plumbing, it is time to prepare the housing for
completion of the installation.
The filter cartridge is shipped outside of the unit housing (in most cases) to protect your filter and drinking water system
from damage during shipping. Be sure to insert the filter cartridge into the drinking water system housing before finalizing
the installation. First, remove the plastic wrapper and instruction wrap from around the filter.
1.
With the housing in an upright position, open the unit by unscrewing the black knob on
the Locking V-Band. Spread it apart and remove the Locking V-Band.
2.
Separate the unit, leaving the black o-ring in place on the housing bottom.
3.
Screw the new filter (cartridge) in the housing top, turning the cartridge in the direction
shown. Be sure that the filter has been screwed in STRAIGHT.
DO NOT OVERTIGHTEN.
4.
Reconnect the housing top with bottom and replace Locking V-Band; replace black
knob and turn until tight. Be sure that the Locking V-Band is fastened tightly by:
a. Checking the V-Band to confirm that it is secured evenly around the housing top
and bottom.
b. Hand-tightening the black knob on the V-Band until it is as tight as possible.
turn to
connect
o-ring
v-band
12
IV.
PREPARING THE HOUSING
IV.A. Filter Cartridge Installation
Multi-Pure units are shipped with the connecting adapters appropriate for your Multi-Pure
Drinking Water System. The following shows the adapters that are shipped with the various
units. You will receive one INLET adapter and one OUTLET adapter. Now is the time to
attach the adapters to the housing top.
Blue Tubing connects the drinking water faucet to the OUTLET port on the housing.
Clear Tubing connects the plumbing to the INLET port on the housing.
1. Connect the appropriate adapter to the OUTLET port on the housing by turning
clockwise. Tighten by hand and then give one to two more turns with a wrench.
2. Connect the INLET adapter or shut-off valve to the INLET opening on the unit housing
by turning clockwise. Tighten by hand and then give one to two extra turns with a
wrench.
OUTLET
INLET
Large Straight
Adapter (#4)
MC730
Small Straight
Adapter (#3)
MC720
IV.B. Attaching the Adapters to the Housing
INLET
OUTLET