Purenex Multipure Aquaversa for model MP750SB - Manual (Page 15)

Your MP750SB or MP1200EL Drinking Water System will sit on the cabinet floor.
Be sure to provide sufficient tubing for conveniently changing the filter when it is time
to replace it. You may also mount the unit on the cabinet wall by using the optional
wall bracket (please contact Multi-Pure's Customer Relations office at 800-622-
9206, extension 175 if you need this bracket).
Mounting Your Unit to the Wall:
Should you choose to mount your unit on the interior cabinet wall (side wall) under
your sink, be sure to provide sufficient tubing for conveniently changing the filter
when it is time to replace it.
1. Fasten the bracket to the wall, making sure
it is in an upright position (the two holes go
on top).
2. Attach the unit to the bracket by tilting the
top of the unit towards the wall and sliding
the V-Band up and into the upper notch on
the bracket.
3. Straighten the unit and let the bottom of the
V-Band settle into the lower notch on the
bracket.
To remove your unit for servicing, reverse the above steps.
MP750SB
Multi-Pure Inline models are ideal for refrigerators, water coolers, or restaurants where all water to a cold water outlet or
faucet is filtered. Model MP750SI includes the housing, filter, adapters, bracket, and screws. The inline models are appro-
priate for an in-line installation and can be used with your existing faucet. It is recommended that the inline models be
installed by a professional plumber in accordance with established plumbing procedures.
MP750SI
15
VI. Placing Your Unit Under Your Sink
VII. Installing Inline Model MP750SI
bracket
V-band
V-band
bracket