V. tubing connections – Purenex Multipure Aquaversa for model MP750SB User Manual
Page 13
Now that you have installed the faucet, connected to the plumbing, and prepared the hous-
ing, you are ready to complete the installation of your Drinking Water System.
Reference Section II for installing the faucet.
Reference Section III for connecting to the plumbing.
Reference Section IV.A for installing the filter.
Reference Section IV.B for connecting housing Inlet and Outlet adapters.
1. Connect the blue faucet tubing to the Small Straight Adapter (#3) that you previously
connected to the OUTLET port.
2. Using wire cutters or knife, cut (square cut) the tip end off of the blue plastic tube con-
nected to the faucet. Do not use scissors.
3. The tubing must be fully inserted in the adapter / switch. It is recommended that you
measure and mark the end of the tubing that you are inserting in the adapter to assure
that it is inserted as far as it will go. The 1/4” blue tubing should be inserted about 5/8”.
4. Push the tubing through the small hole in the adapter until you feel resistance; at this
point, the tubing is not fully inserted. Then push firmly until the tubing is inserted as far
as it will go (see Item 3 above for measurements).
5. Pull to check that the tubing is secure.
Housing Top
Insert tubing and push until you
feel resistance -- at this point,
the tubing is not fully inserted.
Push firmly until the tubing is
inserted as far as it will go.
13
V. Tubing Connections
Note: Use wire cutters or sharp knife to cut tubing. Do not use scissors.
V.A. Connecting the Blue Faucet Tubing to Outlet Port
blue tubing
OUTLET
Adapter
OUTLET
INLET
V. B . C o n n e c t i n g C l e a r Tu b i n g t o I n l e t
Note: Use wire cutters or sharp knife to cut tubing. Do not use scissors.
Be sure to provide sufficient tubing for conveniently changing the filter when
it is time to replace it.
1. Connect the clear 3/8” tubing to the Large Straight Adapter (#4-MC730) which you
previously connected to the INLET port.
2. Using wire cutters or knife, cut (square cut) the tip ends off of the clear plastic
tube which you previously connected to the plumbing. Do not use scissors.
3. The tubing must be fully inserted in the adapter / shut-off valve. It is recommended
that you measure and mark the end of the tubing that you are inserting in the
adapter / valve to assure that it is inserted as far as it will go. The 3/8” clear tubing
should be inserted about 7/8”.
4. Push the tubing through the small hole in the adapter or valve until you feel resistance;
at this point, the tubing is not fully inserted. Then push firmly until the tubing is
inserted as far as it will go (see Item 3 above for measurements).
5. Pull to check that the tubing is secure.
clear tubing
INLET
adapter
Connecting to Straight Adapter
Insert tubing and
push until you feel
resistance -- at this
point, the tubing is
not fully inserted.
Push firmly until the
tubing is inserted as
far as it will go.
Insert blue tubing 5/8”