Juki HZL-35Z - Manual (Page 20)

20
WINDING THE BOBBIN
1. Pass thread from spool through thread guides as
shown.
2. Pull end of thread through hole in bobbin as shown.
3. Push bobbin winder to far left position, if it is not already
there. Place bobbin onto shaft with end of thread
coming from top of bobbin. Push bobbin winder to right
until it clicks. Hold onto end of thread.
4. Start machine. The thread that is held will snap. Bobbin
will cease turning when completely filled. Push shaft
to left to remove bobbin.
2
3
4
1