Juki HZL-35Z - Manual (Page 38)

38
TURNING A SQUARE CORNER
To turn a square corner 5/8" (16 mm) from the fabric edge,
stop stitching with the needle tip piercing the fabric, when
reaching the cornering guide as shown. Raise the presser
foot, turn fabric.
New stitching line will align with 5/8" (16 mm) seam guide
on side of needle plate. Lower the presser foot and begin
stitching in new direction.
DARNING
Drop feed lever ( )
Lower feed dogs and remove presser foot.
Stretch fabric with embroidery hoops with the hole at
center. Holding the needle thread, take one stitch and
pick up bobbin thread through the fabric. Lower presser
bar and start sewing at a slow to medium speed, moving
the fabric back and forth with a steady rhythm. Turn fabric
and sew another layer of stitching across over the first
layer of stitching.
Cornering guide
Guía de esquinas