Juki HZL-35Z - Manual (Page 36)

36
STRAIGHT STITCH
Straight stitch at center needle position with following
settings ;
Stitch pattern dial -
Zig zag width adjusting lever -
Straight stitch at left needle position with following
settings ;
Stitch pattern dial -
Zig zag width adjusting lever -
2
STARTING TO SEW
Before placing the material on the ma chine, see that the
ends of the threads have been drawn about 15 cm to the
rear of the machine. Hold on the threads during the sewing
of the first 3 or 4 stitches of the seam.
Fasten each seam by back tacking at the beginning and
end of the seam.
REMOVING FABRIC
First turn the handwheel towards you until the needle is
at its highest position, then raise the presser foot, draw
materials to the rear and cut off excess thread with the
thread cutter located on the left end of working surface or
on the presser bar.