Multiquip SP2S20H20A - Manual (Page 20)

PAGE 20 — SP213H20A / SP2S20H20A SAWS — OPERATION AND PARTS MANUAL — REV. #1 (05/17/10)
INSPECTION
Hydrostatic Transmission (Self-Propelled models only) -
An EATON® Model 7 hydrostatic transmission (Figure 8)
provides the power for the saw's propulsion system. The
transmission drives a sprocket that directly connects the spline
drive to the rear wheels. The no load forward/reverse speeds
are approximately 24.4 m/min (80 ft/min).
Figure 8. Hydrostatic Transmission
The transmission is factory filled with approved hydraulic fluid
that has a viscosity equivalent to SAE 20W-20. Should additional
servicing be required, the following hydraulic fluids are
recommended:
 General Motors Dextron B
 Ford MM2C-33F
 Ford M2C-41A
 International harvester Hy-Tran Fluids
Figure 9. Transmission Reservoir
DO NOT over fill the fluid reservoir (Figure 9). Note the level
marks on the reservoir.
It is essential to reference the
existing oil conditions (A) cold or (B) hot prior to
operating the saw. Overfilling the transmission with
hydraulic fluid may cause the seals to rupture causing
mechanical damage.
D
CAUTI CAUTI CAUTI CAUTI CAUTION
Gasoline Check
1. Remove the gasoline cap located on top of fuel tank.
2. Visually inspect to see if fuel level is low. If fuel is low,
replenish with unleaded fuel.
3. When refueling, be sure to use a strainer for filtration.
DO NOT top-off fuel. Wipe up any spilled fuel.
Motor fuels are highly flammable and can
be dangerous if mishandled. DO NOT
smoke while refueling. DO NOT attempt to
refuel the saw if the engine is
hot or
running .
WARNING WARNING WARNING WARNING WARNING