Multiquip SP2S20H20A - Manual (Page 36)

PAGE 36 — SP213H20A / SP2S20H20A SAWS — OPERATION AND PARTS MANUAL — REV. #1 (05/17/10)
Engine components can generate
EXTREME heat.
OPERATION
Finishing A Cut
1. Raise the blade out of the cut by cranking the Raise/Lower
handle COUNTER-CLOCKWISE (Figure 37). Raise the
blade high enough out of the cut to clear the surface and allow
the saw to be maneuvered.
2. Shut the engine down according to the SHUT-DOWN PRO-
CEDURES in the next section.
WARNING WARNING WARNING WARNING WARNING
Restarting After Intervention
If cutting is interrupted where the engine stops or is turned off
while the blade is still in the cut:
a. Turn engine Shutdown switch on handlebar to the
"OFF" position.
b. Raise the blade out of the cut
c. Restart the engine as described in the Start-Up sections
on page 27 or page 30.
If cutting is interrupted where the blade is stuck in the cut:
a. Turn Engine Off switches to "OFF".
b. Remove the blade guard.
c. Remove blade mounting bolt and outer flange.
d. Maneuver the saw away from the stuck blade.
e. A parallel cut made next to the blade may be necessary
to free it.
f. Once the blade is freed inspect the blade for damage;
discard if damaged.
e Ensure an undamaged, useable blade is installed on
the saw before cutting is resumed with that saw.
The only acceptable method for freeing a stuck blade is to
remove the saw from the stuck or pinched blade. DO
NOT try to get the blade unstuck using the Raise/Lower
system or by lifting the saw by the lifting bale, etc.
CAUTION CAUTION CAUTION CAUTION CAUTION