Multiquip SP2S20H20A - Manual (Page 30)

PAGE 30 — SP213H20A / SP2S20H20A SAWS — OPERATION AND PARTS MANUAL — REV. #1 (05/17/10)
10. Grasp the starter grip (Figure 29) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
11. If the engine has started, slowly return the choke lever (Figure
22) to the CLOSED position. If the engine has not started
repeat steps 7 through 10.
12. Before the saw is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a loose guard and/or covers.
13. All sawing is done at full throttle. Your engine governor has
been set at the factory to ensure an optimum speed setting.
 DO NOT pull the starter rope all the way to the end.
 D
O NOT release the starter rope after pulling. Allow it
to rewind as soon as possible.
Figure 29. Starter Grip
Figure 28. Throttle Lever
CAUTI CAUTI CAUTI CAUTI CAUTION
MANUAL START-UP (13HP HONDA ENGINE)