Opticon H15 User Manual User Manual
Page 23
Opticon
H15
User Manual
2-16
2.3. Handling the terminal
This section offers the basic procedures for using the Terminal.
2.3.1.
Starting the terminal
Press the power key to turn ON/OFF the Terminal. If the Terminal does not power
on, perform a cold boot. See chapter 2-6 Resetting the Terminal.
CAUTION
: When a battery is fully inserted in Terminal for the first time, the
Terminal powers on and boots automatically.
When the Terminal is powered on
for the first time, it initializes its
system. A splash screen (Figure
2-7) appears for a short period of
time followed by the WinCE 5.0
window.
Figure 2-7. Power-on splash screen
2.3.2.
Power ON/OFF
a)
Turning the Terminal ON
Press the power key briefly (
). If the Terminal does not power on, perform
a cold reset, see chapter 2.6.2. Hard (Cold) Reset.
While the Terminal initializes its file system, the splash screen displays for about
30 seconds followed by the calibration screen. Every time you perform a cold
reset, these screens will appear.
b)
Turning the Terminal OFF
Press the power key again. This action does not actually turn off the Terminal, it
only turns the Terminal into suspend mode. All running applications remain as you
left them, until you press the power key again to resume operation of the Terminal.