Opticon H15 User Manual - Manual (Page 43)

Opticon
H15
User Manual
2-36
• Good scanning position. The reading range is from 50 to 650mm distance.
 Decrease the scanning distance to the barcode when scanning small
barcodes.
 Increase the scanning distance from the barcode when scanning large
barcodes.
 The scanning area is visible by a red laser beam.
Figure 2-19. Good scanning position
• Bad scanning position.
 Make sure that the laser beam sweeps across whole barcode.
 Scanning operations may fail if the laser beam is positioned as below.
Figure 2-20. Bad scanning position
• Upon reading a barcode, the red LED indicator turns on until the trigger is
released, or after five seconds. The green LED and the beep tone indicates a
good read.
NOTE : This product scans using laser light. Never look directly into the laser light
or shine the laser light into the eyes.
2.4.7. Help
Tapping the question mark (?) will retrieve help information for each program.
2.5. Power management
2.5.1. Suspend Mode
The PDT will go into a suspended mode when it is idle for a period of time. The idle
duration can be customized using the Power control panel.
Suspend mode works and looks just like you have turned the unit off. Press the
Power key
to suspend the PDT; press the Power key again for the PDT to
resume its previous state.
Use the Battery power control panel to set the duration to switch state to Suspend
mode when system using battery power. This will save battery power when PDT is
not in use.