Opticon PHL 5300 Quickstart Guide - Manual (Page 11)

9
4. Plug the AC adapter’s (specifically for this product) round connector into
the power jack located in the back of charging cradle. Then plug the other
end of AC adapter into a normal home-use wall outlet. The device will then
start charging automatically.
5. Cold Boot: Use one finger to press and hold the “Power” button on the top
of the Pocket PC, meanwhile, use the tip of the stylus to press down the
“Reset” button located on the left side of the Pocket PC. Then release the
“Power” button and the “Reset” button simultaneously. After rebooting,
follow the instructions on the screen to finish screen alignment…etc, tasks.
6. A brand new Pocket PC takes approximately 8 hours to be fully charged. It
takes about 3 hours to be charged in full thereafter. After charging is
finished, you can then unplug AC adapter and carry around the device
freely. Please charge the device regularity in the future to keep the device
functioning smoothly.
7. “Indicator on the top right corner of this device” will indicate charging or
various other functions in-use.
Charging Charging Finished Low Power
Red light glows Red light off Red light blinks
Cell phone on Reminder or warning
Green light blinks Orange light blinks
If secondary main battery is purchased, it can be charged by plugging in the
charging slot located in the back of charging cradle. “Indicator in the front
of charging cradle” will indicate the charging status.
Charging Charging Finished No Battery
Red light glows Green light glows Indicator off