Orbit Baby Generation-one Toddler Car Seat - Manual (Page 33)

Forwar
d-Facing Installation
64
64
Forwar
d-Facing Installation
65
65
Removing the Braces
1. Uninstall the Toddler Car Seat from your
car.
2. Turn the Locking Knob on the Brace to
UNLOCKED by fi rst pushing it in, then
turning (Photo G).
3. Pull out evenly on both sides of the
Brace until the Brace Rods disengage
completely from the shell (Photo H).
4. By rotating one Brace around, you
can dock the Braces together in their
storage position (Photo I). Replace the
Braces in their Brace Bag and store in
the Cargo Pod of your Orbit Stroller for
later use.
The Toddler Car Seat can still be used
on the Orbit Stroller when the Braces
are installed. Place the Toddler Car
Seat either Forward- or Rear-Facing.
To restore full rotation on the Orbit
Stroller, remove the Braces and store
in the Cargo Pod.
1. Install the Braces onto the Toddler Car
Seat, Forward-Facing: See pages 62-63.
2. Open the Rear Access Panel by
unclipping the Back Clip (Photo J).
3. Remove the LATCH connectors from
their pockets (Photo K). You will notice
the connectors are permanently attached
to the Toddler Car Seat. If you will be
attaching the Top Tether later (refer to
Page 72), unclip and remove the Tether
Hook from the secured ring (Photo L).
4. Extend the LATCH belt by pressing the
buckle’s grey pushbutton adjuster and
pulling on the belt.
Installation with Braces
& LATCH System
(without Orbit Base)
! WARNING !
Refer to your vehicle manual for the
maximum weight rating of its lower
LATCH anchors. Unless a higher
weight is specifi ed by the vehicle
manufacturer, only install with LATCH
anchors until your child reaches 40 lbs.
G
H
I
J
K
Back Clip
Rear Access Panel
LATCH Connectors
L