Orbit Baby Generation-one Toddler Car Seat - Manual (Page 44)

86
86
Securing Y
our Child
Securing Y
our Child
87
87
b) Note which Upholstery slots the two
tabs are in, so that you can change their
location. Then, pull these two tabs away
to free the Adjustable Headrest
(Photo R).
c) Pull the Adjustable Headrest away from
the Upholstery (Photo S).
d) Feed the Headrest tabs back into the
new slots, making sure that they are
both threaded through slots at the same
height on the Upholstery (Photo T).
e) Press the Adjustable Headrest tabs
fi rmly onto the corresponding hook-
and-loop fasteners on the back of the
Upholstery (Photo U).
f) Replace the Upholstery by stretching it
back over the top rim of the Toddler Car
Seat (Photo V).
4. Adjusting the Adjustable Headrest
The Headrest can be adjusted to the height
of your growing child.
a) Pull the top part of the Upholstery away
from the rim of the Toddler Car Seat.
This will allow you to access the back
of the Upholstery where the Adjustable
Headrest is attached with two tabs
(Photo Q).
Adjusting the Restraint Harness to Fit
Your Child cont’d
h) Determine the correct slot, at or just
behind the torso. Keeping the plate
vertical, feed it back down into the shell
in the new slot.
i) Let go of the plate and feed the crotch
buckle up through the Upholstery in the
correct slot (Photo O, previous page).
Pull up on Crotch Buckle to confi rm it is
properly secured.
j) Close the Crotch Buckle Flap (Photo P,
previous page) in the lower Upholstery
and secure the Front Access Panel.
Q
R
S
T
U
V