MacDon 9352c SP - Manual (Page 59)

Form # 147459 Issue 11/06 Web Rev_01 57
MAINTENANCE/SERVICE
Service Procedures
CAUTION: To avoid personal injury,
before servicing machine or opening
drive covers:
1. Move variable speed lever to neutral and
turn steering wheel until it locks to engage
park brake.
2. Fully lower header and reel.
3. Disengage header drive clutch.
4. Stop engine and remove key.
5. Wait for all moving parts to stop.
Wear close-fitting clothing and cover long hair.
Never wear dangling items such as scarves or
bracelets.
Wear protective shoes with slip-resistant soles,
a hard hat, protective glasses or goggles and
heavy gloves.
Be prepared if an accident should occur. Know
where the first aid kit and fire extinguisher are
located and how to use them.
Keep the service area clean and dry. Wet or
oily floors are slippery. Wet spots can be
dangerous when working with electrical
equipment. Be sure all electrical outlets and
tools are properly grounded.
Use adequate light for the job at hand.
Park on level surface when possible. Block
wheels securely.
Replace all shields removed or opened for
service.
Use only service and repair parts made or
approved by the equipment manufacturer.
Substituted parts may not meet strength,
design or safety requirements.
Keep the windrower clean. Do not allow oil or
grease to accumulate on the service platform,
ladder or controls.
Never use gasoline, naphtha or any volatile
material for cleaning purposes. These
materials may be toxic and/or flammable.
Welding Precautions
CAUTION: Avoid possible damage to
the electronically controlled engine
components. Before welding on any
part of the machine, disconnect
battery cables, alternator wire, main wiring
harness (A) and connections to the ECM (B)
located at rear of engine.
STAY CLEAR OF DRIVELINE
AND ALL MOVING PARTS
MAIN WIRING HARNESS
A
B