MacDon 9352c SP - Manual (Page 87)

Form # 147459 Issue 11/06 Web Rev_01 85
MAINTENANCE/SERVICE
Electrical System
LIGHTS AND BULBS (continued)
REPLACING RED TAIL LIGHT BULBS
1. Remove two screws (A). Remove plastic lens.
2. Replace bulb and reinstall plastic lens.
NOTE: Bulb trade #1157.
REPLACING AMBER LIGHT BULBS
1. Remove light (B) from rubber bezel.
2. Replace bulb and reinstall light.
NOTE: Bulb trade #1156.
IMPORTANT: For proper lighting pattern, be sure lights
are installed right side up.
REPLACING GAUGE LIGHT BULBS
1. Turn light switch and ignition key to OFF.
2. Remove six screws (three per side) from instrument
panel (A). While pulling out on top of instrument panel,
pull up until panel clears side console.
3. To replace gauge lights, twist
and pull bulb holder (D) from
back of gauge and replace bulb.
NOTE: Bulb trade #161.
A
RED LIGHTS
REMOVE INSTRUMENT PANEL
A
A
B
AMBER LIGHTS
D