MacDon 9352c SP - Manual (Page 88)

Form # 147459 Issue 11/06 Web Rev_01 86
MAINTENANCE/SERVICE
Electrical System
LIGHTS AND BULBS (continued)
REPLACING DOME LIGHT BULB
1. Remove two screws (D) from plastic lens.
2. Replace bulb and reinstall plastic lens.
NOTE: Festoon Bulb 12V-21 CP
REPLACING TURN SIGNAL INDICATORS
1. Remove six screws around outer edge of cover (F).
Lower cover to expose inner wiring.
2. Push out entire unit (E), detach wiring and replace.
3. Reinstall cover (F).
Electrical System
FUSE BLOCK
CHECKING/REPLACING FUSES
The fuse block is located on the LH side of the
engine compartment mounted to the fire wall.
The fuses are the plastic blade type. To access
the fuse block refer to the illustration and
proceed as follows.
1. Remove screws (A) and remove fuse
block cover.
2. Refer to the decal on the inside of fuse
block cover. See Illustration.
3. To check fuse, pull fuse out of
receptacle and visually examine.
4. To replace fuse, insert into receptacle.
IMPORTANT
Replacement fuses should match rating
on decal.
D
F
E
DOME LIGHT AND TURN INDICATORS
FUSE BLOCK DECAL
A
FUSE BLOCK COVER