RaySafe i2 Dose Manager - Manual (Page 55)

55
RaySafe i2 dose manager user manual – Using the cradle
USInG tHe CRAdle
IntRodUCtIon
Figure 37. The cradle
the cradle is a dock station that lets you connect a dosimeter to a computer for data read out as well as
dosimeter options writing into the dosimeter.
GettInG StARted
NOTE Do not connect the cradle to the computer unless dose viewer/dose manager and the cradle
driver are installed on the computer.
1. Start the dose manager application.
2. Connect a cradle to your computer’s USb port.
3. Put a dosimeter in the cradle.
within a few seconds, dose manager will detect the dosimeter. this is indicated at the top of the dose manager
window by a note “Connected to dosimeter 100001158”, where dosimeter 100001158 is an example of a
dosimeter Id.
dose manager will start loading the dosimeter dose history. this may take up to a few minutes. you can follow
the progress on the progress bar at the bottom of the dose manager window.