Retsch BB 50 - Manual (Page 33)

Cleaning, wear and service
33
Fig. 31: Screw securing adhesive
• Use two new screws (RS) for installation or secure both screws with liquid
screw securing adhesive (RL).
Pos : 12.17 / 0020 Ü berschrif ten/ 1. 1 Ü bers chrift en/ 1. 1 Ü bersc hrift en BD A/ 11 Versc hleiß @ 0\ mod_1226909713106_9. doc x @ 3619 @ 2 @ 1
7.3
47B
Wear
Pos : 12.18 / 0005 R ET SCH/ 0005 RET SCH Bedi enungsanleit ungen Kapitels ammlungen/ BB50/ 0010 R einigung Wart ung Verschl eiß/ 0011 BB50 Modul Versc hleiß @ 5\ mod_1346078787141_9.doc x @ 34765 @ 34 @ 1
7.3.1
54B
Resetting the wear alert
NOTICE
After replacing the breaking jaws, the wear warning should be reset.
Fig. 32: Wear alert
The wear alert (F42) appears when the breaking jaws are worn.
The currently set gap width flashes in the gap width (F1) display and the error
code H43 is displayed in the speed (F2) display.
• Press the STOP button.
7.3.1.1 Setting the operating time until the calibration alert is displayed
You can set the time until the calibration reminder appears. The time until the next
calibration depends on the sample material and application.
• Press the STOP button (F6).
F1
F2
RS
RL