RKI Instruments GX-2001 Canadian Version - Manual (Page 20)

20 • Operation Model GX-2001 Operator’s Manual
Multiple Alarms
If more than one gas alarm is activated, the LCD shows the concentration
of the gas that triggered the last alarm. To see the concentration of the
other gasses, press the DISP button until the gas of interest is displayed.
When the DISP button is pressed, the displayed gas will stay displayed for
20 seconds, then the display will cycle.
For example, if concentrations of both CO and H
2
S in the monitoring
environment were to rise above their respective alarm points and CO was
the first to do so, the concentration of H
2
S would display on the LCD since
it was the most recent alarm event. Pressing the DISP button would display
the concentration of CO for 20 seconds, then HC for three seconds, etc.
STEL
Concentration of CO
or H
2
S rises above the
STEL alarm point
setting.
• Name of gas
displayed.
• Alarm light flashes
once per second.
• Back light turns on.
• STEL blinking.
Pulsing tone once
per second
Unit vibrates once
per second
Over Range • Name of gas
displayed.
• Gas reading
replaced by blinking
brackets.
• Alarm light flashes.
• Back light turns on.
Pulsing tone once
per second
Unit vibrates once
per second
Low Battery Warning • Battery icon
flashes.
None
Dead Battery Alarm • Gas reading
replaced by FAIL.
• Battery icon
flashes.
Double Pulsing Tone
(two pulses in quick
succession)
Sensor Failure • Name of gas
sensor displayed.
• Gas reading
replaced by FAIL.
Double Pulsing Tone
(two pulses in quick
succession)
Table 4: Alarm Types and Indications
Alarm Type LCD Indications Other Indications