RKI Instruments SDM-2009 - Manual (Page 24)

20 • Setting the Operational Parameters in Edit Mode
Parameters” on page 14.
5. Use the BUMP
T
and CAL
S
buttons to scroll through the different calibration
parameters. Do not scroll past the GAS--IN parameter until you have finished
making any desired changes.
6. To edit a parameter, press and release the EDIT ENTER button when that
parameter is displayed. An “E” will appear to the right of the parameter name
indicating that the parameter value can be changed. In the example below, the
AIR--IN parameter has been selected for updating.
7. Use the BUMP
T
and CAL
S
buttons to set the parameter to the desired
value, then press and release the EDIT ENTER button. The “E” to the right of
parameter name will disappear.
8. Repeat step 6 - step 7 to set any other parameters.
9. When you are done setting the parameters, use the BUMP
T
button to scroll
past the GAS--IN parameter screen. The screen will indicate that the
parameter changes have been saved.
The instrument will return to the home screen.
45
AIR--IN
45
AIR--IN
90
GAS--IN
45 90
DECISION
50 12.0
TRANSMIT
CO ppm H2S ppm
CH4 %LEL OXY vol%
50 25.0
45
E AIR--IN
30 90
DECISION