Schroth Racing All models - Competition Instructions User Manual
Page 33
• Follow the wrapping instructions above at both strap ends.
• Follow the wrapping instructions above at both strap ends.
• Make sure, when the latch is buckled in, the bent part of the buckle
latch faces towards the body. See figure below.
• Make sure, when the latch is buckled in, the bent part of the buckle
latch faces towards the body. See figure below.
• In a pull-down configuration the adjuster shall be as close as possible
located to the buckle
• In a pull-up assembly make sure, the adjuster is well separated from
the strap hole in the bucket seat so the adjuster will not interfere with
the seat bucket during a crash. See section “Anchorage Locations
and Geometries”
D
OUBLE
B
AR
L
AP
B
ELT
I
NSTALLATION
This installation system is only used in some open wheel race cars.
• Bars must not bend under strap load of at least 14.7 kN.
• All edges must be appropriately rounded (>1,5 mm radius)
• The bars must directly clamp on to each other firmly clamping the
webbing.
• Make sure the belt is correctly routed as recommended by FIA
and shown in following sketch.
W R O N G
R I G H T
- 32 -