Schroth Racing All models - Competition Instructions - Manual (Page 43)

7. Make sure the bend of the bracket aligns to the direction of pull
deviating not more than plus or minus 25°.
8. Before fully tightening position the bracket to align with direction of
pull.
9. Use e.g. “Loctite 243” to secure bolt.
10. Tighten the bolt. Follow all instructions and information, WARNINGS,
WAIVER and SAFETY INSTRUCTIONS boxes provided under section
“Important Information About Bolts and Torques”.
11. Make sure the bracket has not turned out of direction of pull. If it
has, repeat the procedure as described.
B OLT - IN B RACKET B 24.15.13
1. This bracket is used in made to measure racing harnesses only.
2. is commonly used for 50 mm [2”] and for a fold in 75 mm [3”] sewn
in assembly.
3. It can also be used in conjunction with 50 mm [2”] and 75 mm [3”]
webbing 3-bar slide wrap mount or 50 mm [2”] webbing D-Ring
[LV 4] wrap mount.
4. 7/16” 20 UNF shoulder bolt and provided washer is standard.
5. Bushing sleeves for 8 mm, 5/16”; or 10 mm/5/8” bolts are available
optional. Bolts will not be supplied by SCHROTH. Choose from bolts
with grade 8.8 or up only. For installation follow assemblies shown in
section “Bracket Installation”.
6. Make sure the bend of the bracket aligns to the direction of pull
deviating not more than plus or minus 25°.
7. Use e.g. “Loctite 243” to secure bolt.
8. Tighten the bolt. Follow all instructions and information, WARNINGS,
WAIVER and SAFETY INSTRUCTIONS boxes provided under section
“Important Information About Bolts and Torques”.
7/16” shoulder bolt
9. Make sure the bracket can swivel after bolt is tightened.
profiled washer
- 42 -