Schroth Racing All models - Competition Instructions User Manual
Page 55
• Tighten shoulder belts securely.
• Make sure the shoulder harness is properly positioned on an Head
and Neck Support (HANS made by SCHROTH
®
) if worn. Adjuster must
be on lower 70 mm of the HANS
®
yoke.
• For adjuster positioning using a HANS
®
specific double-shoulder belt
see instructions under paragraph 3.5 in this section.
3.3 Hybrid
TM
models
• Loosen the shoulder belts so they will not pull-up the rotary buckle
when engaged.
• Pull up anti sub-straps so they run flat over the upper thighs and their
inner angles are facing each other.
• Hold anti-sub strap in place by pulling with the middle finger on sewn
on coloured strap loop.
• Slide lap belt latches through end loops of anti-sub straps and secure
in rotary buckle.
• Hook in second shoulder belt latch.
• Tighten lap belt securely. In case the racing car is equipped with a
sliding seat track, it is recommend that the seat be slid rearwards by
W R O N G
lap belt
C O R R E C T
- 54 -