Schwank IEP-4024 - Manual (Page 16)

16
IM110822
RD: AUGUST 2011
RL; 1A
BA
InfraSave IEP-4024 Manual
Heat Lamp Replacement : … continued
Step 4
Remove the 2 Phillips screws that fasten the electrical con-
nection box front face plate in place.
Step 5
Slide the connection box front face plate out from the electri-
cal connection box.
Step 6
Slide power cord retainer plate from electrical connection box
(top surface).
Step 7
Loosen screws in terminal block to remove wires as required:
RED wires connect to Lamp #1 (closer to connection box)
BLUE wires connect to Lamp #2 (further end from box)
Do not disconnect power supply wires
Loosen the threaded clamping collar on the Liquid Tight
Connector located behind the wiring terminal
Pull wires out through the Liquid Tight Connector and top
of electrical connection box
Step 8
Slide lamp wires out of electrical connection box.
Set electrical connection box aside.
Electrical
Connection
Box
Loosen screws as required