Schwank IEP-4024 - Manual (Page 17)

17
IM110822
RD: AUGUST 2011
RL; 1A
BA
InfraSave IEP-4024 Manual
1
2
Bottom Edge
Heat Lamp Replacement : … continued
Step 9
Remove interior end plate from heater: 6 Phillips screws
fasten the heater body end plate in place.
Step 10
Slide top cover plates out each end of top side of heater.
Step 11
Remove the center Face Plate:
 The BOTTOM edge of the center Face Plate does
not have a lower lip
 Insert a fine edged slot screw driver between the
heater body and the BOTTOM edge of the face
plate
 Pry the face plate from the heater body, and re-
move to storage
Step 12
Slide the end face plates out from each end of the heater.
Step 13
NOTE: For this Step, keep the heat lamp retainer clips in
place at each end of lamps. Heat lamp is fragile - use cau-
tion when feeding wires through holes.
Carefully feed each lamp wire from the top of the heater
through the hole in the heater body so that the wire is inside
the heater body (same as the lamp).