Barco R9001330 - Manual (Page 62)

Start Up of the Adjustment Mode
9-2
Start Up of the Adjustment Mode
9-2 5975288 BARCOGRAPHICS 8200 110497
5975288 BARCOGRAPHICS 8200 110497
Adjustment Mode
All source set ups, picture tunings and geometry are made while in the 'Adjustment
mode' . Press the
ADJUST or ENTER key to enter the 'Adjustment mode'.
You are now in the 'Adjustment mode'. The control stick (RCU) or '+ or '-' keys (local
keypad) are used to make menu selections and also for adjustments. The
ENTER and
EXIT keys are used to move forward and backward through the menu structure. The
ADJUST key can be used to terminate the adjustment mode while any path selection
menu is displayed.
There are 4 possible paths to follow once in the Adjustment mode. They are :
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with or
then <ENTER>
<EXIT> to return.
Random Access - Random Access should be selected if the user is
used to set up a source.
Service - Service should be selected if the user intends to change
general settings such as password, language, address, etc.or some
service actions as reset lamp run time, panel adjustments, etc. or get
set-up information.
Installation - Installation should be selected if a new input module is
installed or a new source is connected to an existing input module.
Also when the projector is relocated in a new configuration.
Guided - Guided should be selected if the user intends to perform a
complete new set up. All of the necessary adjustments or set ups are
made in a predetermined sequence.
Adjustment Mode
All source set ups, picture tunings and geometry are made while in the 'Adjustment
mode' . Press the
ADJUST or ENTER key to enter the 'Adjustment mode'.
You are now in the 'Adjustment mode'. The control stick (RCU) or '+ or '-' keys (local
keypad) are used to make menu selections and also for adjustments. The
ENTER and
EXIT keys are used to move forward and backward through the menu structure. The
ADJUST key can be used to terminate the adjustment mode while any path selection
menu is displayed.
There are 4 possible paths to follow once in the Adjustment mode. They are :
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with or
then <ENTER>
<EXIT> to return.
Random Access - Random Access should be selected if the user is
used to set up a source.
Service - Service should be selected if the user intends to change
general settings such as password, language, address, etc.or some
service actions as reset lamp run time, panel adjustments, etc. or get
set-up information.
Installation - Installation should be selected if a new input module is
installed or a new source is connected to an existing input module.
Also when the projector is relocated in a new configuration.
Guided - Guided should be selected if the user intends to perform a
complete new set up. All of the necessary adjustments or set ups are
made in a predetermined sequence.