USG Exterior Ceiling Applications Systems Guide - Manual (Page 46)

45 USG Exterior Ceiling Applications
Seismic Perimeter Applications
ZXLA with Sheetrock
™
Lay-In
Ceiling Panel ClimaPlus
™
Fixed Perimeter Treatment Options 1 ACM7 Seismic Clip
29 Wall Molding
12 ga. hanger wire
M7A molding
screw attach through
either top hole into bulb
attach ACM7 clip to
wall through the top
holes of the clip wings
AX or ZXLA main
or cross tee
compression post
8" max.
ACM7 clip hold-down nail to prevent panel uplift
(see accompanying section detail)
Sheetrock ™ Lay-In
Ceiling Panel ClimaPlus ™
8" max.
12 ga. hanger wire
M20A molding 1
AX or ZXLA main
or cross tee
compression post
hold-down nail to prevent panel uplift
(see accompanying section detail)
blocking for perimeter ends
of tees to prevent uplift
stabilizer
bar
Sheetrock ™ Lay-In
Ceiling Panel ClimaPlus ™
tee
min. 6d common hold-down
nails or similar device shall
inserted in alternating directions
Sheetrock ™ Lay-In
Ceiling Panel ClimaPlus ™
Hold-Down Nail
¹Other seismic detailing may be required. Please visit www.USG.com or www.seismicceilings.com for more information.
Note: Min. 6d common hold down nails or similar device shall be inserted in alternating directions.