Vararam G8 Ram-AIR V - Manual (Page 2)

To Start your installation:
1. Remove the factory air box and intake tube, if you still have one.
2. Slide wiring harness (found on passenger side of the back of the radiator shroud, Gray in color) off
to the passenger side to allow the radiator to lean back.
3. Removing radiator tabs – (IMPORTANT READ COMPLETELY THROUGH) don’t get confused here.
A. Pull UP on the center tab on this bracket. Pull it all the way out.
B. Look “INSIDE” the bracket with a flashlight, there is a release in here. Use the flathead
screwdriver by pushing it into release tab and pry back on the tab and pull “UP on the main
bracket “AT THE SAME TIME” it will come up with ease. You are removing these
completely. The new VR system takes there place. (the VR system is designed as a stressed
member to become your new radiator support)