Vigo VG06063 User Manual
Page 11
11
12
G. HANDLE INSTALLATION
1. Assemble the door handles (#11) to the doors (#12).
[SEE FIG.10]
FIG.10
MODEL VG06063
2
1
3
15
F. INSTALLING THE SIDE PANEL SUPPORTS
1.
Install the support assembly (#3) onto the side glass panel (#4) approximately two-thirds
away from the wall. Use hex key to tighten to screws. [SEE FIG.9]
2.
Install the support assembly to the structural arm (#2) and wall connector (#1). Make sure it's
level.
3.
Mark the holes on the wall for the mounting screws for the wall connector.
4.
Remove the support assembly. Drill holes into respective marks and put plastic anchors (#18)
in them. Not necessary if installing into studs.
5.
Replace wall connector to proper position. Screw it in to the wall with 1 1/8" screws (#15).
6.
Slide the structural arm (#2) into the wall connector (#1). Tighten all set screws.
7.
Repeat Steps 1 through 6 to install the other support assembly to the other side glass panel.
18
!
WALL
WALL
SIDE PANEL
LEVEL
FIG.9
11