Vigo VG06063 - Manual (Page 7)

GLASS SUPPORT (6)
GASKET
SIDE GLASS PANEL
HEX SCREW
VIEW FROM THE TOP
WALL
FIG.5
HEX SCREW (16)
!
!
OUTSIDE OF SHOWER INSIDE OF SHOWER
FIG.4
THIN
GASKETS
5
6
WALL SIDE
DOOR SIDE
19
16
4
7
MODEL VG06063
B. INSTALLING SIDE GLASS PANEL
1. Install the side seal strip (#5) to the wall side of the side glass panel (#4). Make sure to leave a
3/8" gap at the bottom. [SEE FIG.4]
2. Screw in the glass support (#6) to the side glass panel using the hex key (supplied) making sure
to slide it back as far as possible from the glass before you tighten. The part that connects the
wall should be facing in. [SEE FIG.5] Be sure to use gaskets on both sides of the panel. The
glass holes are elliptical allowing for 5mm out of square.
If your shower stall is out of square more than 5mm from the top of the glass to the
bottom of the glass then this can cause the shower to potentially leak and can cause
potential fatal harm.
3. Place the side glass panel into the bottom rail (#8). Use the level to position the side glass panel
correctly. Make sure the seal strip is against the wall.
4. Mark holes on the wall for the mounting screws.
5. Remove the side glass panel. Drill holes into respective marks and insert plastic anchors (#19)
inside them. Not necessary if installing into studs. Studs are the preferred means of
installation, anchors can pull out of the wall causing property damage and bodily harm.
6. Replace the side glass panel back onto the bottom rail and screw it to the wall with 1 5/8" screws
(#16).
7. Repeat steps 1 through 6 for the other side glass panel (#4). [SEE FIG.5]
3/8"
[10mm]
MAKE SURE TO
LEAVE A GAP OF
3/8" [10MM] FROM
THE BOTTOM OF
THE GLASS
5
4